Custom Engineering Plastic Components
Machined and fabricated engineering-plastic components for wear, low friction, corrosion resistance, weight reduction and equipment interfaces.
Materials in scope
POM / Acetal for dimensional stability and general machine parts; Nylon / PA for toughness and wear; PTFE for low friction and chemical resistance; PEEK for higher temperature and demanding service; UHMW-PE for sliding wear and impact; HDPE for corrosion resistance and lower-load components. Final selection depends on the actual application.
Custom component scope
Equipment guides, wear strips, slide plates, rollers, bushings, spacers, scrapers, change parts, gripper pads, vacuum-tooling elements and corrosion-resistant replacement components can be produced to drawings, samples and interfaces.
Application review
Load, speed, friction, wear, chemical exposure, temperature, moisture, dimensional stability and mating materials influence plastic selection and tolerance feasibility.
Quantity and process review
Prototype, low- and medium-volume requirements can be discussed according to material yield, setup, geometry and inspection needs.
Information that helps us review
Part or application, drawing or sample, material, initial quantity, expected repeat demand, working condition, inspection and delivery requirement.
Accepted uploads: PDF, DWG, DXF, STEP, STP, IGES/IGS, JPG, PNG and ZIP.
Email: service@valueanchorsc.com
WhatsApp: +86 158 5123 6667